| 1. | High precision positioning control system
高精度位置控制系统 |
| 2. | The closed loop position control system of a new type nc bevel roll tester
新型数控锥齿轮滚动检查机闭环位置控制系统设计 |
| 3. | The paper introduces the designing of a fuzzy neural network controller which is applied to the valve position control system of industrial stove
摘要介绍模糊神经网络控制器的设计方法，并将其应用到工业炉阀门位置的控制系统中。 |
| 4. | Secondly , servo control tache is introduced briefly , and how to realize a closed - loop position control system which uses stepping motor as driver component is presented
其次，对于伺服控制环节，实现了以步进电机为驱动元件的闭环位置控制系统。 |
| 5. | 6 . the simulation test and practical test on the lake has been finished about the dynamic positioning control system concerned in this paper , which has been delivered to the consumer
6 )完成了本文研究的动力定位控制系统的仿真试验及湖上试验，并已交付用户使用。 |
| 6. | This test - bed is made of five part , oil supplying system , oil heating system , specimen constant temperature system , position control system and loading system
该试验台共有五个部分，包括供油系统、油液加热系统、试件恒温系统、位置控制系统和液压伺服加载系统。 |
| 7. | As far as position control system , the performance of stability and precision of the system were analyzed . based on the theoretical studies and the analysis of simulation , we use the
在理论分析和仿真的基础上,通过试验验证了控制系统设计的可行性,并且对系统的低速特性、最大速度、最大加速度和频响等进行了试验研究。 |
| 8. | The second , it is proposed that a foc mentioned above can be modeled with a fast time optimal position control system based on the pontryagin ' s minimum principle , which may become a speed - sensorless time optimal one by using speed estimator
接着，分析了pontryagin极小值原理，指出用bang - bang开关信号可对上述系统实现最优时间控制，若速度量采用估计，则生成无速度传感器的时间最优系统。 |
| 9. | The main work of the thesis is as follows : 1 . the feasibility of the scheme in engineering is discussed by means of analyzing the strategy of position control system . 2 . the mathematical model of the position control system is established and analyzed in theory
论文以研配压机位置控制系统的研究为题目，其主要工作如下： ?对1000kn双侧翻转研配压机进行了简介，对电液比例控制系统进行了分析。 |
| 10. | Control software is written in c language . the semi - physical simulation system is setup to test the software . after that , the brake control system , the position control system , the load control system and the energy control system are combined together and inspected
用c语言编制控制软件，为了验证控制软件的正确性，建立了半物理仿真系统，对刹车控制系统、位置控制系统、载荷控制系统、能量控制系统进行了连接和检验。 |
